APOGEE ACOUSTICS Full Range Ribbon Speaker System Instrukcja Właściciela

APOGEE ACOUSTICS INC. APOGEE FULL RANGE RIBBON SPEAKER SYSTEM OWNER'S MANUAL AND ASSEMBLY INSTRUCTIONS

BIAMP Operation 1. CONNECT crossover between Pre Amp and Power Amps. 2. For APOGEE crossover go to Step 3. For other manufacturers follow instruct

SPEAKER CONNECTIONS FOR BI AMP 1. Connect the woofer cables to the woofer binding posts of the transformer box. Blue cable to blue binding post and b

APOGEE PASSIVE CROSSOVER INTRODUCTION The Apogee passive crossover is designed to provide the electrical separation of woofer and midrange-tweeter s

TABLE CX -1 Load Amplifier Resistor Amplifier Impedence RHI & RLO Spectral DMA - 100 10K NONE Perreau 2150 10K NONE M

SPEAKER ADJUSTMENTS The performance of the Apogee Ribbon Speaker will respond to adjustments that can be made in three separate ways. The first way t

SPECIFICATIONS FULL RANGE RIBBON SPEAKER Three element system - Woofer - Midrange – Tweeter Frequency response - below 25 - 30 kHz Sound Pressu

LOW IMPEDANCE DIRECT DRIVE Introduction & Description The APOGEE Acoustics Direct Drive is an alternate embodiment of the speaker. It is intende

(page13)

DIRECT DRIVE RETROFIT PROCEDURE The following assembly steps are to be done prior to hookup of the direct drive on those systems being retrofitted fr

(Page 15)

Full Range Ribbon Speaker System Apogee Acoustics has resolved fundamental problems inherent to ribbon acoustical transducer design. For the first ti

(Page 16)

(Page 17)

(Page 18)

(Page 19 )

(Page 20)

(Page 21 )

APOGEE ACOUSTICS' FULL RANGE RIBBON SPEAKER SYSTEM APOGEE ACOUSTICS takes great pride in announcing a revolutionary development in loudspeaker d

TABLE OF CONTENTS Pages PREPARATION (Steps 1-6) ---------------------------1-3 ASSEMBLY (Steps 7-11) -----------------------------3-5 PLA

SPEAKER SET-UP The APOGEE speakers' performance is affected by the quality and compatibility of the front end equipment, turntable, cartridge,

CAUTION - USE CARE - DO NOT allow any object to touch the ribbons!! (3) Unpack outer midrange tweeter-left, MRT-L, and MRT-R and place the outer b

(5) Place the right midrange tweeter, MRT-R on boxes A and B. (see FIG. 2). The bottom of the MRT-R should be toward speaker position. a) Remove t

(9) Attach base plate to woofer. a) Use the T-Handle wrench and 1/2" long 1/4-20 Flat Head Socket Screws, and secure base plate to woofer

(12) Placing speaker upright. This procedure requires two people with clean hands. The stronger person should be positioned to lift the top secti